How to Install A Kitchen Faucet

How to Install A Kitchen Faucet

Whether you're handling a leaky sink or looking to update your hardware, installing a replacement kitchen faucet maybe a project that the majority of anyone can easily implement. As long as you're employed slowly and follow the directions, you'll add a gorgeous faucet to your kitchen with zero emergency calls to the plumber.

But always remember before purchasing a replacement faucet, a note of your current setup. Look under the sink to ascertain what percentage holes yours has usually between one and 4. This determines the sort of faucet which will work together with your sink. A single-hole faucet is often installed during a three- or four-hole sink by adding a deck plate, but not the other way around.

Step 1

Remove any and every one item from under your sink to make the maximum amount of room possible for this project. Place the rubber or plastic gasket, or trim ring, over the tap holes within the sink and set the deck plate. This may also help avoid any possible damage to your belongings just in case of a leak. Keep towels nearby to wash up any drips. 

Step 2

Turn off the water system lines to the tap before you begin any work. Make certain to shut off both the cold and predicament valves, turning all clockwise until they won’t turn anymore. Test the tap by trying to show it on the sink to make certain the water won’t begin. Keep the tap within the “on” position to alleviate any water pressure.

Step 3

Once the water is safely off, unhook (counterclockwise) the recent and cold water system lines together with your wrench. Keep your bucket and towels nearby, as touch water may drip out. Turn the water on slowly and check for leaks. Tighten connections if necessary.

Step 4

Use a little bucket under the connections to catch water as you disconnect supply lines. Using your screwdriver, unscrew your old faucet from under the sink. Use your wrench as required. Pull the old faucet, up and out, from the highest. Pack up any residue from under the old faucet.

Step 5

Grab your new faucet, also because of the installation manual. Remember, each faucet is exclusive and should have a special set of instructions to properly install. Feed your new faucet through the opening where you removed the old one. It’s going to be helpful to possess a second set of hands to assist keep the highest secure while you go under the sink.

Step 6

Using your screwdriver, secure the new faucet from underneath the sink. Once secure, attach your cold and predicament lines to their valves and tighten them together with your wrench. For added protection, wrap your threaded pipes with Teflon tape to stay your connections leak-free.

Step 7

Remove the aerator from the tap. Slowly turn the water on and let it run, aerator free, for a couple of minutes to clear the lines. Recheck everything for leaks and make readjustments. Slowly activate your water system valves. Check the tap to make certain both the recent and cold water is functioning properly.